Pop-up 2.4 kW SPS features:

• All you need: fold out + plug and play. All cables are connected
• Outside sockets
• Inside sockets
• Ventilation
• Door lock
• Shelf for battery chargers (for tools or mobile phones or etc.)
• Cable hole in the floors for hidden connection
• Space for storage inside the cabin
• Space for storage on the outside platform
• Long term useable materials (vacuum impregnated wood, sealed roof, hot zinc coated frame, water resistant plywood)
• Two persons can fold out and fold in system
• Tiny space for transportation and storage (2.4 m width and 1 m depth and up to 2.2 m height)
• One SPS fits one car parking space
• It is possible to connect few SPS to one grid (Please contact us for this option, we will find better solution)
• Lift hooks for crane lift and bottom frame for pallet lifter.

Power plant assemble

Power plant assembly should be made as follow:

Proper orientation: Solar panels must be oriented to the South for the maximum effectiveness. The solar panels are angled 25 degrees.

• Unload from truck or trailer. For load and unload there are two possibilities: forklift possibility grabbing underfloor metal frame or with crane by lifting on by hanging holes on the roof.
• The power plant must be placed on the hard even surface. If the surface is not hard (for example grass) it must be placed some wide tiles or other hard materials under the frame legs. 
• Unfold the floors and fix them with extra fixes. 
• Release the panels from the transportation position. 
• Lift back panels up and fix them with metal legs to the floor. Release the second panels` frame and open it like a book. Fix the second panels` frame with extra 4 legs made of tubes. Add extra metal rope lines and tight them.
• Lift front panels up and fix two legs to the sides. Open side metal frames and lift the front panels up and fix the legs to the opened side frames. Fix the side frames to the floor.
• Tight all nuts and bolts. 
• Place the weight on the front floors and on the back floors. It should be around  400-500 kg weight on front floors and around 200-250 kg weight on back floors. The wind resistance was calculated on 30 m/s wind blowing from the North. If the wind is stronger, it should be placed more weight. The weight could be: Sand barrels, concrete bricks or blocks and other long lasting weight. Weight is not added to the plant. 
• Ground the solar plant. Ground points are on the main box frame. Ground and measure the resistivity. (This should be done by electricians and according to local laws). 
• Solar systems outputs must be connected to the house or other grid.

Safety requirements:

• The Solar power plant system must be grounded for long term use. The ground must be made according to local rules and restrictions. Please, advice with your local electrician. 
• During the very strong wind (over 30 m/s) fold down the front panel or add extra weight load in on the front and back floors (Add around extra 400-500 kg on front floors and plus 200-250 kg on back floors for wind up to 40 m/s). 
• Fold down the front panel during the winter in high snow areas or fold down all the SPS during the winter. There should NOT BE over 5 cm of snow on the panels. Please, remove the snow if it is more. You can do this by using a brush.
  

SPS possible solutions

ON-Grid system – this solution is suitable for houses, business or other users if they are able to give all produced electricity to the grid and get it back when they need. The house or other user always has electricity. Must be an agreement with the grid operator.

HARD Hybrid system – similar solution as On-Grid system, but here system has extra battery pack. Produced electricity is used or loaded to the battery and if it produces even more it goes to the grid. Used electricity first comes from the solar system, then if it is too low power or night time electricity comes from the battery. If the battery goes low, then electricity comes from the grid. This is the most expensive but most effective system. The house or other user always has electricity. Must be the agreement with the grid operator. Hard Hybrid systems can be used as SOFT hybrid systems as well. HARD Hybrid systems can be used as OFF-Grid systems as well.

SOFT Hybrid system – it is a more simple system then Hard hybrid. Soft hybrid systems have extra batteries as well, but do not give electricity to the grid. So it gives electricity primarily from the panels when it is sunny day, during the night or cloudy days from the battery and if the battery is low, then electricity comes from the grid. The house or other user always has electricity. Do not need the agreement with the grid operator. SOFT Hybrid systems CAN NOT be used as HARD Hybrid systems. SOFT Hybrid systems can be used as OFF-Grid systems as well.

OFF-Grid system – is the simplest independent electricity system. It has batteries and it would be good to get as big a battery as possible. The solar power goes directly to the appliance or to the battery. If there is more power than used and the battery is full, then solar power is lost. If no sun and battery are low – then no electricity power at all. The only one system for the remote areas, for short term use (for rent purposes). Do not need the agreement with the grid operator. OFF-Grid systems CAN NOT be used as any Hybrid systems.

If you do not know what system is good for you, please contact us, we will try to help you figure out. 

Battery options

Lithium batteries – best for long term use, it has the most cycles rate, low weight and good service in cold conditions. Best for homes, business long term run.

Acid batteries – old school batteries which weigh much more are bigger than lithium batteries. (In the SPS system weight is ok, because it adds some weight and saves from very strong winds). Not so good in cold conditions, in winter time (it loses capacity). These batteries have much lower cycle rates. Good for warm regions, for short term low budget systems (war or disasters zones, rent).

One or three phase system

One phase system – most simple and economic system, that should be used for any short term uses for Soft hybrid and Off grid systems. This system is not good for On grid and Hard hybrid systems if the house, business or other user already has a three phase grid.

Three phase system – more expensive and with more specific hardware. This system is necessary only for ON grid and Hard hybrid systems and only if the user already has a 3 phase system in the house or other appliance. Three phase system is good for bigger solar systems than 3 kW power (It can work with the Pop-up Solar 4.8 kW Power plant System. As well, a 3 phase system can be installed on ON grid Pop-up Solar 2.4 kW Power plant System).

Samples

Pop-up Solar 2.4 kW Power plant System for RENT.

We offer SPS for short and long term rent.

SPS for short term rent should be a Soft Hybrid system with one phase electricity. It would have hybrid inverter 3 kW power, 2.4 kW power solar panels, 5 kWh capacity Lithium Phosphate (lifepo4) batteries or Acid AGM batteries.

SPS for long term rent should be a Soft Hybrid system with one phase electricity. It would have hybrid inverter 3 kW power, 2.4 kW power solar panels, 10 kWh capacity Lithium Phosphate (lifepo4) batteries.

Pop-up Solar 2.4 kW Power plant System for remote areas and long term use.

SPS should be with OFF – Grid 3 kW power inverter, 2.4 kW power solar panels and 20 kWh capacity Lithium Phosphate (lifepo4) batteries.

Pop-up Solar 2.4 kW Power plant System for small house or business with grid electricity option.

SPS should be ON – grid or HARD Hybrid 3 kW power inverter, 2.4 kW power solar panels and without or with 5 capacity Lithium Phosphate (lifepo4) batteries or Acid AGM batteries.

Prices

Pop-up Solar 2.4 kW SPS prices can vary according to the components. Some components could be changed to the other manufacturers` components with same or better performances.

• Pop-up Solar 2.4 kW OFF-Grid 3 kW 1 phase inverter + 5 kWh Acid AGM battery (4 batteries 12 v * 120 ah) – 7900 eur.

Main parts:

Photovoltaic panels – 400 w or more power: Canadian solar, Omnis Power or similar.

Inverter – Green Cell Solar Off grid converter with MPPT 48VDC/3000W/230VAC.

Battery – 4 pcs Acid AGM 12 v * 120 ah (Many manufacturers)

• Pop-up Solar 2.4 kW -Hybrid ON/OFF Grid 3kW 1 phase inverter + 5 kWh battery Lithium Phosphate battery – 9900 eur + VAT + Shipping. Can work as HARD, SOFT and OFF Grid systems.

Main parts:

Photovoltaic panels – 400 w or more power: Canadian solar, Omnis Power or similar.

Inverter – SofarSolar HYD 3000-EP

Battery – Lithium Phosphate Sofar GTX 5000

• Pop-up Solar 2.4 kW -Hybrid ON/OFF Grid 3kW 1 phase inverter + 10 kWh Lithium Phosphate battery – 12900 eur + VAT + Shipping. Can work as HARD, SOFT and OFF Grid systems.

Main parts:

Photovoltaic panels – 400 w or more power: Canadian solar, Omnis Power or similar. Inverter – SofarSolar HYD 3000-EP

Battery – 2 pcs Lithium Phosphate Sofar GTX 5000 

• Pop-up Solar 2,4 kW -ON Grid system with 2.4-3 kW 1 phase inverter – 7400 eur + VAT + Shipping. Can work only ON Grid system and requires agreement with grid.

Other system configurations available according to request. Please contact us.